Input
Measured variable position
Stroke length 50…1500 mm Output
1. Voltage 0…10 VDC or 10…0 VDC, 0…10 VDC and 10…0 VDC (min. load controller > 5 kOhms)
2. Current 4…20 mA or 20…4 mA (min./max. load: 0/500 Ohms)
3. Start/Stop RS-422 differential signal for position additional
available: serial parameter upload of stroke length,
offset,gradient, status and manufacturer number Accuracy
Resolution analog: infinite
start/stop: 0.1 / 0.01 / 0.005 mm
Linearity < ± 0.02 % F.S. (minimum ± 60 μm)
Repeatability < ± 0.005 % F.S. (minimum ± 20 μm)
Update frequency, stroke dependent analog: < 3 kHz / start/stop: controller dependent
Ripple analog: < 0.01 % F.S. / start/stop: controller dependent Mounting position any
Magnet speed any
Operating temperature -40 °C…+75 °C
Dew point, humidity 90 % rel. humidity, no condensation
Electronic ingress protection 1 IP67 if mating cable connector is correctly fitted
Shock test 100 g (single shock) IEC-Standard 60068-2-27
Vibration test 10 g / 10…2000 Hz IEC-Standard 60068-2-6 (resonance frequencies excluded)
EMC test Electromagnetic emission EN 61000-6-4 (for use in industrial environment)
Electromagnetic susceptibility EN 61000-6-2
The sensor meets the requirements of the EC directives and is marked with CE
Desigh/Material
Sensor housing aluminum
Piston aluminum Installation
Mounting type adjustable mounting feet or adjustable rod ends M6
Mounting position any Eletrical connection
Connection type 5 pin connector M12 (analog); 8 pin connector M12 (start/stop)
Supply voltage 24 VDC (+20 % / -15 %)
Current consumption 50…140 mA (start/stop 50…100 mA)
Ripple < 0.28 Vpp
Electric strength 500 VDC (DC ground to machine ground)
Polarity protection up to -30 VDC
Overvoltage protection up to 36 VDC
| 
