Input
Measured variable position
Stroke length 50…2500 mm / 50…3000 mm for output start/stop Output
1. Voltage 0…10 VDC or 10…0 VDC, 0…10 VDC and 10…0 VDC (controller
input resistance RL: > 5 kOhms)
2. Current 4…20 mA or 20…4 mA, (min./max. load: 0/500 Ohms)
3. Start/Stop RS-422 differential signal additionally available: serial parameter
upload of stroke length, offset, gradient,status and manufacturer
number Accuracy
Resolution analog: infinite
start/stop: 0.1 / 0.01 / 0.005 mm
Linearity 1 ± 0.02 % F.S. (minimum ± 60 μm)
Repeatability ± 0.005 % F.S. (minimum ± 20 μm)
Update frequency, stroke dependent analog: < 3 kHz / start/stop: controller dependent
Ripple analog: < 0.01 % F.S. / start/stop: controller dependent Operating condition
Mounting position any
Magnet speed any
Operating temperature -40 °C…+75 °C
Dew point, humidity 90 % rel. humidity, no condensation
Electronic ingress protection 2 IP67 if mating cable connector is correctly fitted
Shock rating 100 g (single shock) / IEC-Standard 60068-2-27
Vibration test 15 g / 10…2000 Hz IEC-Standard 60068-2-6 (resonance frequencies excluded)
EMC test Electromagnetic Emission EN 61000-6-4 (for use in industrial environment)
Electromagnetic Susceptibility EN 61000-6-2
The sensor meets the requirements of the EC directives and is marked with CE.
Design/Material
Sensor head aluminum
Sensor housing aluminum
Position magnet see chapter position magnets Installation
Mounting type adjustable mounting clamps Electrical connection
Connection type 5 pin connector M12 (analog); 8 pin connector M12 (start/stop)
Supply voltage 24 VDC (-15 % / +20 %)
Current consumption 50…140 mA (start/stop 50…100 mA)
Ripple < 0.28 Vpp
Electric strength 500 VDC (DC ground to machine ground)
Polarity protection up to -30 VDC
Overvoltage protection up to 36 VDC
| 
