Input
Measured value position, the position is measured separately on two or three position measuring systems.
Stroke length 50…2900 mm Output
Voltage 0…10 / 10…0 / -10…+10 / +10…-10 VDC (min. load controller: > 5 kOhms)
Current 4(0)…20 mA / 20…4(0) mA (min/max. load: 0 / 500 Ohms)
Null position/end position adjustment 100 % of electrical stroke (minimal range 50 mm) Accuracy
Position measurement:
– Resolution analog
– Linearity 1 < ± 0.02 % F.S. (minimum ± 50 μm)
– Repeatability < ± 0.001 % F.S. (minimum ± 2.5 μm)
– Hysteresis < 4 μm
– Sample rate < 2.5 ms
– Ripple < 0.01 % F.S. Operating conditions
Magnet movement velocity any
Operating temperature electronic housing -40…+75 °C
Dew point, humidity 90% rel. humidity, no condensation
Ingress protection IP67, IP68 for cable outlet (with proper mating connector)
Shock test 100 g (single shock) IEC standard 60068-2-27
Vibration test 5 g / 10…2000 Hz IEC standard 60068-2-6 (resonance frequencies excluded)
EMC test electromagnetic emission EN 61000-6-4 (for use in industrial environment)
electromagnetic immunity EN 61000-6-2
The sensor meets the requirements of the EC directives and is marked with CE. Design / Material
Sensor electronics housing aluminum
Sensor rod with flange stainless steel 1.4301 / AISI 304
Operating pressure 350 bar, 690 bar peak
Position magnet Ring magnets, U-magnets Installation
Mounting position any orientation
Sensor rod threaded flange M18 × 1.5
Position magnet mounting plate and screws from antimagnetical material Electrical connection
Connection type 6 pin connector M16 or integral PUR-cable
Operating voltage 24 VDC (-15 / +20 %)
Current consumption 100 mA typical (each channel)
Ripple ≤ 0.28 Vpp
Dielectric strength 500 VDC (DC ground to machine ground)
Polarity protection up to -30 VDC
Overvoltage protection up to 36 VDC
| 
